LabQuest 2
==========

The LabQuest is capable of measuring many different quantities depending
on which probe(s) is/are attached.

Temperature
~~~~~~~~~~~

1. Attach temperature probe to USB port (upper left side).

2. Turn on power (left upper side) — The unit should show temperature.

   1. Press **Duration:** and set to 300 s.

   2. Press **Done**.

   3. Press **Rate:** and change to 10 samples/s.

   4. Press **Done**.

3. Set up your experimental run with the temperature probe appropriately
   positioned.

4. Press |labquest-run.png| to start recording the temperature. The
   display will change to a graph.

   .. note::
      On your second and subsequent runs, you will get a message about
      what to do with your previous run. Press **Discard**.

5. Allow the temperature to be recorded for about 15 s to be sure you
   have a flat baseline. Also, *record the initial temperature in your
   notebook*.

6. Perform a trial run.

7. After the temperature has leveled off for at least 20 s, record the
   final temperature, then press |labquest-stop.png| to stop recording.

8. Go to Step 3 for subsequent runs.

9. When you have completed the experiment, clean the probe and power off
   the LabQuest.

pH
~~

.. note:: I need a procedure.

.. |labquest-run.png| image:: images/labquest-run.png
   :width: 20px

.. |labquest-stop.png| image:: images/labquest-stop.png
   :width: 20px